jcb RENTAL Series User Manual

CONTROL PANEL – DSE 8610
This button is only active in the STOP/RESET mode, MANUAL mode. Pressing the Start button in Stop/Reset
Mode powers up the engine’s ECU but does not start the engine. This can be used to check the status of the
CAN communication and to prime the fuel system
Used for navigating the instrumentation, event log and configuration screens.
Used to silences the audible alarm in the controller, de-activates the audible alarm output (if configured) and
illuminates all of the LED on the module’s facia as a lamp test function.
Close Generator- The Close Generator button controls the operation of the generator load switch and is only
active in the Manual Mode once the generator is available. Pressing the Close Generator button when the
generator is available and off load automatically instructs the generator to synchronise and once in sync, to be
place the generator on load (‘Close Generator Output’ becomes active). If the generator bus is dead (has not
supply on it) the generator is placed on load immediately. Further presses of the Close Generator button have
no effect.
Open Generator- The Open Generator button is only active in the Manual Mode and allows the operator to
open the generator load switch. Pressing the Open Generator button when the Generator is on load,
automatically ramps the load off the generator and then takes it off load (‘Close Generator Output’ becomes
inactive). Further presses of the Open Generator button have no effect.
16
Please consult your manual for full information or consult your local dealer

jcb RENTAL Series Specifications

General

Brand	jcb
Model	RENTAL Series
Category	Portable Generator
Language	English