CONTROL PANEL - DSE
Operation
Single generator, controlled manually through its genset controller. Load is monitored
by the operator.
Starting Procedure
Perform all the pre-start checks before starting the generator.
Turn ON battery isolator
1. Make sure ALL power output supply MCCB’s are switched off.
2. Check that the emergency stop button is fully out, if necessary twist to reset the
button.
3. Complete all pre-start, system and engine checks.
4. Turn on the Digital Controller (DC) switch to power the DSE Controller.
5. Wait for few seconds, to allow the controller to power up and display to stabilise.
6. Make sure that the power on LED (Light Emitting Diode) is illuminated on earth
leakage trip and there is no trip active where required.
7. Press the stop/reset button on DSE to clear any elapsed alarms
8. When ready “Press the Manual mode button” on DSE controller.
9. When ready “Press Start button” and the machine will start
10. The Generator will attempt three start cycles before registering a fault / alarm
11. The engine will run up to speed and stabilise.
12. Check that the machine operation is correct using the screen information.
13. Make sure the power on LED is illuminated on earth leakage trip and there is no
trip active.
14. Manually turn on the main power supply MCCB.
15. Turn on any socket MCCB’s that may be fitted and required .
16. The generator can now be loaded.
17. If the earth leakage relay trips at this point consult the site electrical installation
engineer.
17
Please consult your manual for full information or consult your local dealer
For synchronising instructions using the DSE8610 controller,
please consult the operators manual or contact your local
dealer.
To Next Page
Loading...
Need help?
General
