jcb RENTAL Series User Manual

MAINTENANCE SCHEDULE - ENGINEER
27
Please consult your manual for full information or consult your local dealer
Component Task 300 600 1200
Emergency stop switches
Check (operation)
☐ ☐ ☐
Earth leakage RCD
(Residual Current Device)
1)
Check (operation)
☐ ☐ ☐
External power socket box
(2)
Check (condition)
☐ ☐ ☐
Battery terminals and voltage
Check (condition)
☐ ☐ ☐
Battery clamps security and cleanness
Check (condition)
☐
Control panel events history
Check
☐
☐
☐
Bus bar cover safety switch
Check (operation)
☐
☐
☐
Bus bar terminals
Check tightness
☐
☐
☐
Machine earth connections
Check (condition)
☐
☐
☐
Engine and controller harness
Check condition and connections
☐ ☐
☐
Generator alternator cables
Check (condition)
☐
☐
Generator alternator terminals
Check tightness
☐
☐
☐
Alternator and engine mounting bolts
Check tightness
☐
☐
☐
CCV (Crankcase Ventilation)
filter
Clean
☐
☐
CCV filter
(2)
Change
☐
Exhaust ducts
Check (condition)
☐ ☐
All hoses
Check (condition)
☐
☐ ☐
Engine oil
(2, 3)
Change
☐ ☐
Engine oil filter
(2, 7)
Change
☐ ☐
Fuel pre
-filter
(2, 4, 7)
Change
☐ ☐
Fuel filter
(2, 4, 7)
Change
☐ ☐
Fuel tank breather
(8)
Clean
☐
Fuel tank breather
(2)
Change
☐
Air filter outer element
(5)
Change
☐
Coolant (inorganic)
(6, 10)
Drain and Fill
☐
Radiator
Clean
☐
☐
Turbo charger
Check (condition)
☐
FEAD(Front End Accessory Drive)
belt condition/tension
Check (condition)
☐ ☐
☐
FEAD belt
Change
☐
After treatment system
(9)
Forced regeneration
☐
☐
Exhaust gas after treatment system visual inspection
Check (condition)
☐
☐
(1) In any case, every time the indicator is red.
(2) In case of low use: 12 months.
(3) For the oil specifications, refer to the table of the oils (Technical Data> Fluid, Lubricants and Capacities>
General).
(4) If the clogged filter warning signal activates, the filter must be replaced. If the water in pre-filter signal does
not deactivate after draining, the filter must be replaced.
(5) Interval to be halved for environmental conditions characterised by a high concentration of dust.
(6) Every 1200 hours or 2 years whichever is sooner. Coolant compliant with specifications ASTM D 6210; mixed
50% with water in the case of a concentrated product.
(7) Use only JCB specified filters.
(8) Or every 6 months.
(9) To be performed prior to engine oil change.
(10) Check which coolant type is installed in the machine before topping up the coolant. Mixing of different
coolant types is not recommended and may result in invalidation of the warranty offered by JCB. In the event of
mixing or if the coolant type is to be changed, the coolant circuit should be completely drained and flushed twice
with clean water before re-filling with fresh coolant.

jcb RENTAL Series Specifications

General

Brand	jcb
Model	RENTAL Series
Category	Portable Generator
Language	English