Operation
Walk-Around Inspection
19 9831/3200-3 19
Walk-Around Inspection
General
The following checks must be made each time you return to the machine after leaving it for any period of time.
We advise you also to stop the machine occasionally during long work sessions and do the checks again.
All these checks concern the serviceability of the machine. Some concern your safety. Get your service engineer
to check and correct any defects.
1. Check for cleanliness.
1.1. Remove dirt and debris, especially from around the linkages, rams, pivot points.
1.2. Make sure the platform floor and handrails are clean and dry.
1.3. Clean all of the safety and instructional labels. Replace any label that is missing or cannot be read.
2. Check for damage.
2.1. Examine the machine generally for damaged and missing parts.
2.2. Make sure that all of the fasteners and pivot pins are correctly installed.
2.3. Check the operation of the platform side rails.
2.4. Check the condition of the tyres.
2.5. Check for leaks
3. Make sure that all of the access panels are closed correctly.
3.1. If access panels are installed with locks, we recommend that you lock them to prevent theft or
tampering.
4. Check the operation of all controls.
5. Check the operator's manual is in good condition and is kept in the operator's manual storage compartment.
6. Check the level of the hydraulic fluid and for leaks.
7. Check the visual condition of the batteries, cables and wiring.
8. Check the operation of the safety equipment.
Refer to: Check (Operation) (Page 66).
To Next Page
Loading...
Need help?
General
