STARTING AND OPERATING 179
Lane Changing
ACC may not detect a vehicle until it is
completely in the lane in which you are
traveling. In the lane changing example below,
ACC has not yet detected the vehicle changing
lanes and it may not detect the vehicle until it's
too late for the ACC system to take action. ACC
may not detect a vehicle until it is completely in
the lane. There may not be sufficient distance to
the lane-changing vehicle. Always be attentive
and ready to apply the brakes if necessary.
Lane Changing Example
Narrow Vehicles
Some narrow vehicles, such as motorcycles,
traveling near the outer edges of the lane or
merging into the lane are not detected until they
have moved to the center of the lane. There may
not be sufficient distance to the vehicle ahead.
Narrow Vehicle Example
Stationary Objects And Vehicles
ACC does not react to stationary objects and
stationary vehicles. For example, ACC will not
react in situations where the vehicle you are
following exits your lane and the vehicle ahead
is stopped in your lane. Always be attentive and
ready to apply the brakes if necessary.
Stationary Object And Stationary Vehicle Example
PARKSENSE REAR PARK ASSIST — IF
EQUIPPED
The ParkSense Rear Park Assist system
provides visual and audible indications of the
distance between the rear fascia/bumper and a
detected obstacle when backing up (e.g. during
a parking maneuver). For limitations of this
system and recommendations, see
Ú page 183.
ParkSense will retain the last system state
(enabled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
4
21_JL_OM_EN_USC_t.book Page 179
To Next Page
Loading...
Need help?
General
