SPECIAL DESIGN FEATURES
MACHINED ALUMINUM CHASSIS: Precision-machined chassis with integrated heat-sinks,
milled from a solid block of aircraft grade aluminum, provides exceptional thermal
heat transfer/dissipation, RFI/EMI shielding, resonance control, and minimizes micro-
phonically induced micro-vibrations from any source.
BALANCED TOPOLOGY: Inherent cancellation effects of balanced topology implemented
throughout all power and input/output circuits ensures greatly reduced distortion and
noise under dynamic signal conditions.
HIGH-PRECISION SURFACE MOUNT COMPONENTS: Extensive use of Lead (Pb)-free, low
temperature coefficient, active and passive surface-mount components results in
signicantly smaller loop areas, reduced circuit capacitance and inductance, and
introduces less noise than conventional leaded components.
THIN-FILM RESISTORS: All resistors are low noise, 0.1% thin-lm type for extremely low
thermal noise which complement the low-noise characteristics of the active circuitry.
TEFLON SIGNAL WIRING: All signal carrying input and output wires are teon insulated
for low dielectric energy storage, ensuring that each audio note is reproduced
naturally and decays into the deeper silence of the music.
TRANSFORMER-COUPLING AND ISOLATION: Transformer coupled input circuitry provides
universal component compatibility and virtually eliminates ground loop noise and RFI/
EMI. Transformer coupling ensures identical amplier overall gain when using
unbalanced input adapters.
HIGH-EFFICIENCY SWITCH-MODE POWER SUPPLY: Highly efficient, compact, light weight,
DC switch-mode power supply provides optimum voltage regulation for all circuits
and operating conditions, and allows for quiet operation over a wide range of AC
mains power sources.
FRONT PANEL STANDBY BUTTON: Illuminated front panel push-button switches the
amplier into standby mode (< 0.5 watt consumption). An internal switch allows the
user to dim the front panel indicator light "ring" or shut off the light altogether when
the amplier is powered on.
REMOTE ON/OFF: A 1/8” (3.5mm) mini plug connector on rear panel permits amplier
power on/standby switching in remote and home theater applications.
REVA2
MODEL 125 STEREO AMPLIFIER
PAGE 6
To Next Page
Loading...
Need help?
General
