6
TUNER OPERATION
AM/FM Band Selector (BAND)
Press the BAND button (5) during radio play to
switch between three FM bands and one AM
band. “F1”, “F2”, “F3” or “AM” will appear in the
display to indicate the band currently selected.
Tuning
Automatic Tuning
Press the >>| button (14) to tune upward in
frequency and the |<< button (13) to tune
downward in frequency. The unit will
automatically stop at the next strong station. If
the Local mode is active, the radio will seek the
next strong local station when either button is
pressed.
Manual Tuning
Press the >>| (14) or |<< (13) button for more
than two seconds to select manual tuning
mode. “MANUAL” will appear in the display.
Press the Up or Down Tuning buttons to move
radio frequency up or down two digits at a time.
Press and hold the Up or Down Tuning buttons
to quickly advance to a certain frequency.
Release when the desired frequency is
reached. If tuning is not adjusted within five
seconds of entering manual tuning mode, the
radio will revert to automatic tuning and “AUTO”
will appear in the display.
Scan Tuning (SCAN)
Press the SCAN button (15) to scan upwards
through all the strong channels in the current
band. The unit will pause and play each station
for five seconds, and the station frequency will
flash in the display during this time. Press
SCAN again to stop scanning and listen to the
current station.
MP1313
1
9
10
8
5
16
6
4
3
2
14
25
13
17
19
22
20
21
23
24
18
15
11
12
7
LIFT
US/EU (EUROPEAN) FREQUENCY SWITCH
On the right side of the chassis, under the
mounting sleeve, is a switch labeled US/EU
that allows the customer to switch between
US and EU (European) frequency spacing.
Press the RESET button after moving the
US/EU switch.
I D 3I D 3
MP1313
To Next Page
Loading...
Need help?
General
