4
Warning
1. Read and understand the entire owner’s manual before attempting assembly or operation.
2. Read and understand the warnings posted on the machine and in this manual. Failure to comply with
all of these warnings may cause serious injury.
3. Replace the warning labels if they become obscured or removed.
4. This sander is designed and intended for use by properly trained and experienced personnel only. If
you are not familiar with the proper and safe operation of a belt/disc sander, do not use until proper
training and knowledge have been obtained.
5. Don’t use power tools in damp or wet locations, or expose them to rain.
6. This sander is intended to be used with wood and wood products only. Use of this sander and a dust
collector with metal products is a potential fire hazard. If a dust collector is not used with this machine,
remove the dust chutes.
7. Do not use this sander for other than its intended use. If used for other purposes, Walter Meier
(Manufacturing), Inc., disclaims any real or implied warranty and holds itself harmless from any injury
that may result from that use.
8. Always wear approved safety glasses/face shields while using this sander. (Note: Everyday
eyeglasses only have impact resistant lenses; they are not safety glasses.) Also use face or dust
masks if the cutting operation is dusty.
9. Before operating this sander, remove tie, rings, watches and other jewelry, and roll sleeves up past
the elbows. Remove all loose clothing and confine long hair. Non-slip footwear or anti-skid floor strips
are recommended. Do not wear gloves.
10. Some dust created by power sanding, sawing, grinding, drilling and other construction activities
contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples
of these chemicals are:
• Lead from lead based paint.
• Crystalline silica from bricks, cement and other masonry products.
• Arsenic and chromium from chemically treated lumber.
Your risk of exposure varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area and work with approved safety
equipment, such as face or dust masks that are specifically designed to filter out microscopic
particles.
11. Do not operate this machine while tired or under the influence of drugs, alcohol or any medication.
12. Make certain the switch is in the OFF position before connecting the machine to the power supply.
13. Make certain the machine is properly grounded.
14. Make all machine adjustments or maintenance with the machine unplugged from the power source.
15. Remove adjusting keys and wrenches. Form a habit of checking to see that keys and adjusting
wrenches are removed from the machine before turning it on.
16. Keep safety guards in place at all times when the machine is in use. If removed for maintenance
purposes, use extreme caution and replace the guards immediately after maintenance is complete.
17. Make sure the sander is firmly secured to the stand or bench before use.
18. Check damaged parts. Before further use of the machine, a guard or other part that is damaged
should be carefully checked to determine that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting
and any other conditions that may affect its operation. A guard or other part that is damaged should
be properly repaired or replaced.
19. Provide for adequate space surrounding work area and non-glare, overhead lighting.
To Next Page
Loading...
Need help?
General
