11
To pair your Jetson Beam with your Bluetooth enabled device, follow these
steps:
1. Turn on the Jetson Beam so that it will become discoverable on your device.
2. Make sure the Bluetooth function in your handheld device and in the Jetson
Beam is turned on.
3. Open the Ride Jetson app in your device, and locate the Bluetooth icon in
the top left corner.
4. Tap on the Bluetooth icon, and from the device list, select your Jetson Beam.
5. You will be prompted to enter a password. Default password is “000000”
6. Your Ride Jetson app should now be paired with your Jetson Beam, and
ready to use.
NOTE: When your app is not connected via Bluetooth, the Bluetooth logo in
the app will be white. When your app is connected via Bluetooth, the Bluetooth
logo in the app will turn green.
Pulsing Beam Light
Once your Jetson Beam Scooter is in motion, the pulsing beam light located
on the handlebar stem will automatically turn on. The throttle sensor on deck
senses when you step off – once you step off, the pulsing beam light will auto-
matically shut off after 60 seconds.
Rear Wheel
Rear wheel LED lights will change from color (matching your Jetson Beam
model) when in motion, to red when braking.
To Next Page
Loading...
Need help?
General
