EasyManuals Logo
Home>JML>Massager>circulation enhancer

JML circulation enhancer User Manual

JML circulation enhancer
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
How to operate
For Body – BAND 2
Using the Gel Pads
Connect the output wire to the gel pads. Connect the other end of the output wire to the
output jack on ElectroFlex. Remove the protective film from the adhesive pads. Attach the
gel pads to the skin. Press the on/off button for 3 seconds to turn on the unit andadjust the
stimulating mode and output intensity to the desired level. (The display will show the mode
and level that you selected and start to count down).
1. Plug the 2 cables into the cable jack at the side of the unit. (See Figure 6).
2. Connect pin of the cable to the gel pad. (See Figure 7).
3. Remove the protective film from the gel pad, and attached the 4 pads to the area of the
body you wish to treat.
4. Repeat operation as in foot instructions, adjust the intensity using Band 2.
5. Gently increase the intensity setting by pushing the button “
”. Or decrease intensity
setting by pushing the button “
”. (See Figure 8). The LCD will show the level selected
(see Figure 9). When you reach the desired Level the icon will blink. To stop the blinking and
maintain the intensity press the “
” button 5 times.
6. To terminate the massage period, turn off the unit a tanytime by pressing the on/off Button
for 3 seconds. The unit has an auto timer, it will start to count down from 25 minutes of
massage and switch off automatically.
If you want to use with 2 gel pads only, then you must connect 1 gel pad to Jack A
and 1 gel pad to Jack B.
Care of your Gel Pads
Never stick two adhesive pads to each other. Keep the adhesive gel pads clean, do
not expose them to high temperature or direct sunshine. If the electrode gel pads are
insufficiently adhesive or dirty, wipe with a damp or change for new ones. Replacement parts
will be available directly from BioEnergiser or your distributor. Do not clean the electrode gel
pads with any chemical. ALWAYS try and protect the gel pads store on the gel
pad protector when not in use, as illustrated.
BAND1
BAND2
Min
Fig 6 Fig 7 Fig 8 Fig 9
13
Shoulder/Back Thighs Tummy Lower back Arms

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JML circulation enhancer and is the answer not in the manual?

JML circulation enhancer Specifications

General IconGeneral
BrandJML
Modelcirculation enhancer
CategoryMassager
LanguageEnglish