PROGRAM
PROGRAM
2
Quick Start Guide
For detailed operation of your ElectroVita™ Circulation Enhancer Electrical Stimulator please
refer to the comprehensive instructions within this manual.
To use the Circulation Enhancer immediately follow this 5 point quick start guide.
1. Remove your ElectroVita Circulation Massager from the
packaging. Connect the DC adapter to a suitable mains
outlet and plug the small DC socket into the device.
2. Turn on the power the central display will light up blue for
2-3 seconds and then turn off again, this is normal. Hold
down the central power switch for 3-4 seconds. The main
display will light up blue and remain on.
3. Remove your footwear and socks or stockings. Your feet
need to be completely bare to experience the
ElectroVita micro current stimulation massage therapy.
4. There are 10 different treatment programmes, each
offering a range of micro-current massage therapies.
Select a number from 1 - 10 by pressing the P+ and P–
buttons. We suggest you try all 10 over time to decide
which best suits you.
5. Sit in a comfortable chair. Place your bare feet on the left
and right foot plates. Increase the intensity levels for
each foot by pressing the
to increase the intensity
and
to decrease for BAND 1. The intensity level ranges
from 0 to 40, slowly increase the level until you begin to
feel the micro-current stimulation.
For a full explanation of setting the intensity refer to page 13.
To Next Page
Loading...
General