How to operate
Connect with the supplied AC/DC Power Adapter
Plug the DC plug of the power supply into the socket on the side of ElectroVita (see Figure
10. Plug in power adaptor to a suitable wall socket. (Make sure that the input voltage of the
wall socket is suitable for the supplied adaptor).
Inserting Batteries
If you want to use the ElectroVita with battery powerinstead of the supplied main adaptor, the
battery compartment is located on the underside of the unit.
Remove the battery cover from the unit by removing the screw with a screwdriver. Insert
three new 1.5V size C batteries with the + and - marks correctly aligned.
Note on batteries: Do not mix different types of batteries or an old battery with a new one.
To prevent the risk of leakage or explosions, never recharge the batteries, apply heat or take
them apart. When not using batteries, remove them to prevent battery drainage. If liquid
leaks from the batteries, throw them away. Thoroughly clean the battery compartment
with a dry cloth.
Changing the Sole Massage Roller
The sole massage roller is interchangeable. The roller is fixed into position between the two
locking locators. These push in to the main body of the ElectroVita to hold the sole massage
roller firmly in place. To Remove the locking locators you will need to squeeze the locator on
the outside face this will push the locking locator out of its fixed position and allow you to
remove and change the roller.
14
To Next Page
Loading...
General