5 Operation
5.1 Operating equipment
1 Crank 3 Low gear 5 Lower
2 High gear 4 Raise 6 Landing gear
foot
ATTENTION!
When you have finished turning the crank handle,
slowly take the strain off the crank. There is a risk of the
crank recoiling.
High gear (2): To lower and retract the landing gear quickly
and to bridge ground clearance.
Low gear (3): To raise and lower the laden and unladen
trailer.
Gear change
High gear (2): Remove the crank from the parking hook and
pull it out fully until the gear engages. A slight
turning motion facilitates the gear change.
The gear locking mechanism must engage.
Low gear (3): Remove the crank from the parking hook and
push it in fully until the gear engages. Finally,
hang the crank in the crank holder. A slight
turning motion facilitates the gear change.
The gear locking mechanism must engage.
EN
Modul B & OPTIMA MUB 006 003 M01 (REV-A) 07-2020 9
To Next Page
Loading...
Need help?
General