– 18 –
❶
❺
❸
❷
❹
1) Press ON button ❶ of the power switch to turn
ON the power.
The power switch is in its ON state when the "I"
mark is pressed. It is in its OFF state when the
"○" mark is pressed.
If the power indicator LED on the panel does
not light up after having turned ON the power
switch, immediately turn OFF the power switch
and check the supply voltage. In addition, in
such a case as this, re-turn ON the power
switch when 2 to 3 minutes or more have
passed after turning OFF the power switch.
2) When the needle bar is not in UP position, it
automatically turns to the UP position.
When turning ON the power, the needle bar moves.
Do not put your hands or things under the needle.
3) The pedal is operated in the following four steps:
a. The machine runs at low sewing speed when you
lightly depress the front part of the pedal. ❷
b.
The machine runs at high sewing speed when
you further depress the front part of the pedal.
❷
(If the automatic reverse feed stitching has been
preset, the machine runs at high speed after it
completes reverse feed stitching.)
5) When one-touch type reverse feed switch ❻ is
pressed, the sewing machine performs reverse
feed stitching. The quantity of light of the LED
can be adjusted by turning control knob ❼.
4) Reverse feed stitching at the beginning of sewing,
reverse feed stitching at the end of sewing and
various sewing patterns can be set on built-in panel
❺
of the machine head.
c. The machine stops (with its needle up or down) when you reset the pedal to its original position.
d. The machine trims threads when you fully depress the back part of the pedal. ❹
* When the auto-lifer (AK device) is used, one more operating switch is provided between the sewing ma-
chine stop switch and thread trimming switch. The presser foot goes up when you lightly depress the back
part of the pedal ❸, and if you further depress the back part ❹, the thread trimmer is actuated.
When starting sewing from the state that the presser foot has been lifted with the Auto-lifter and you de-
press the back part of the pedal, the presser foot only comes down.
6) When sewing is completed, press OFF button ❶ of the power switch to turn OFF the power switch after
conrming that the sewing machine has stopped.
In the case the machine is not used for a long time, remove the power plug from the plug receptacle.
❻
❼
III. FOR THE OPERATOR
1. Operating procedure of the sewing machine
To Next Page
Loading...
Need help?
General
