Page 12/24
Original issue
May 2009
Service Manual
HZL-27Z
Model
7. M position
Attention： Confirm “6. Needle position at straight stitching” before this checking.
〔Checking〕
1. Set machine for straight stitching at center needle position.
2. Turning hand wheel by hand, lower the needle and check if needle point comes to the
center of needle plate hole.
〔Adjustment〕
1. Remove front cover.
Adjust by turning screw A.
Center needle position is shifted to right. → Turn it clockwise.
Center needle position is shifted to left. → Turn it counter clockwise.
Ａ
To Next Page
Loading...
Need help?
General
