14
SPOOL PINS
Place a spool of thread on the spool pin. Secure it with
the spool cap (A) leaving a gap between the spool cap
and the reel of thread to allow the reel to rotate freely.
Pull up the spool pin (B) . This is used for bobbin winding
when the machine is already threaded.
A
B
PRESSER FOOT LEVER
There are three positions for your presser foot.
1. Lower the presser foot to sew.
2. Raise the lifter to the middle position to insert or
remove fabric.
3. Lift it to its highest position to change the presser foot
or to remove thick fabric.
PRESSURE REGULATOR
For most fabrics set the control at 3. For thicker ones
increase it to 4 and for finer ones decrease to a lower
number.
To Next Page
Loading...
Need help?
General
