22
1
2
3
4
5
THREADING THE BOBBIN THREAD
1. Raise the needle to its highest position by rotating the
hand wheel towards you.
2. Remove the hook cover by pushing the release button
to the right while pushing the left corner of plate.
3. Insert the bobbin making sure the bobbin rotates anti-
clockwise.
4. Pull thread through the slot (A) and then to the left.
With a finger held gently on top of the bobbin, pull
thread through the slot (B)
until you hear a clicking
sound, and then leave about 15 cm of thread.
5. Replace the hook cover onto the needle plate.
To Next Page
Loading...
Need help?
General
