Insert the bobbin in the bobbin
case with the thread running in
a counterclockwise direction
(arrow).
Inserting the bobbin
Attention:
Turn power switch to off ("O")
before inserting or removing the
bobbin.
When inserting or removing
the bobbin, the needle and
presser foot must be fully
raised.
Pull the thread through the slit
(A).
With a finger held gently on top
of the bobbin.
Draw the thread at the arrow
markings into the stitch plate
thread guide from (A) to (B).
Pull the thread at the arrow
markings into the stitch plate
thread guide from (B) to (C).
To cut off excess thread pull
thread back over the cutting off
blade at point (C). Close the
bobbin cover plate.
A
C
A
B
B
To Next Page
Loading...
Need help?
General
