JUKI HZL-70 series User Manual

1. Place the thread and
onto the spool pin.
For smaller spools of thread,
place with the
small side next to the spool
or use the small .
2. Draw the thread from the
spool through the upper
thread guide.
3. Guide the thread around the
thread guide pulling the
thread through the pre-
tension spring as illustrated.
4. Thread the tension module
by passing the thread
between the silver discs.
5. Then, down and around the
check spring holder.
6. At the top of this movement,
pass the thread from right to
the left through the slotted
eye of the take-up lever and
then downwards again.
7. Pass the thread behind the
flat, horizontal thread guide.
Guide the thread through
the wire loop.
Pull the end of the thread
through the needle from
front to rear, and pull out
about 10 cm of thread.
Use the needle threader to
thread the needle. (On the
next page.)
spool
cap
spool cap
spool cap
Threading the upper
thread
Note:
It is important to carry out the
threading correctly as by not
doing so several sewing
problems could result.
Start by raising the needle to
its highest point, and also
raise the presser foot to
release the tension discs.
6
5
7
16

JUKI HZL-70 series Specifications

General

Brand	JUKI
Model	HZL-70 series
Category	Sewing Machine
Language	English