Changing the needle position
Changing the stitch length
These setting apply only to
patterns 00-04. The pre-set
position is "3.5", center position.
When you press the "–" stitch
width adjustment button, the
needle position will move to the
left. When you press the "+"
stitch width adjustment button,
the needle position will move to
the right.
To shorten the stitch length,
press the "–" stitch length
adjustment button. For a longer
stitch length, press the "+" stitch
length adjustment button.
Generally speaking, the thicker
the fabric, thread and needle,
the longer the stitch should be.
Adjusting the stitch width
Adjusting the stitch length
The maximum zigzag stitch
width for zigzag stitching is
"7.0"; however, the width can be
reduced on any patterns. The
width increases as you press
the "+" stitch width adjustment
button from "0.0-7.0".
The density of zigzag stitches
increase as the setting of stitch
length approaches "0.3".
Neat zigzag stitches are usually
achieved at "1.0-2.5".
Closed up zigzag stitches
(close together) are referred to
as a satin stitch.
Straight stitches and
needle position
0.5 1.0 2.0
3.0
4.5
0.0 2.0 3.5 5.0 7.0
00
01 02 03 04
T
Zigzag stitches
0.0 1.0 3.0 5.0 7.0
0.5 1.0
2.0
3.0 4.5
T
A
05
06
07 07
To Next Page
Loading...
Need help?
General
