Note:
When the memory the full with
30 units of patterns, the
machine will beep to signal it.
Use the arrow " " or " "
button to check what you have
programmed.
If you wish to delete a certain
stitch within in the memory
mode, use the " " button or
" " button until the actual
stitch number is displayed.
Press the " " button to delete
the selected pattern and the
next pattern in the back will
move forward.
Clearing patterns or letters
Adding patterns or letters
Attention:
The selected pattern will be
cleared from the memory
module after closing the
machine if you do not press the
" " button again when you
have completed your selection.
Press the " " button to leave
the memory mode and return to
the Direct mode.
While in the memory mode,
press the " " button or the
" " button until the stitch
number you have selected is
displayed, then add the new
stitch or change the stitch
length, width, Auto-stop or
mirror, if desire.
Attention:
The memory has to contain less
than 30 patterns after selected
pattern or letter can be inserted.
To Next Page
Loading...
Need help?
General
