Warning functions
Instruction message display
- When operating correctly
: 1 beep
- When the memory is full 30
units of pattern
: 2-short beeps
- When operating incorrectly
: 3-short beeps
- When the sewing machine is
in trouble and can't sew
: 3-short beeps
Warning beeping sound
It means that the thread is
twisted or jammed and the hand
wheel axle can't move.
Please look through the "Trouble
shooting guide" on page 69/ 70 to
find the solution.
After the problem has been
solved, the machine will continue
to sew.
- Lowering the buttonhole lever
When you select any
buttonhole pattern or darning
pattern, LCD screen will show
the figure " ". It is to remind
you to lower the buttonhole
lever.
- Bobbin winding
When the bobbin winder
spindle is activated for bobbin
winding (in the rightmost
position) this figure " "
appears on the LCD screen as
a reminder.
Note:
If the problem is still not solved,
please contact your local dealer.
Attention:
During the sewing, if the thread
get jammed inside the hook
stopping the needle from moving
and you continue pressing the
foot control, the security switch
will stop the machine completely.
In order to restart the sewing
machine, you will have to turn
the on/off switch to the OFF
position and then ON again.
To Next Page
Need help?
General
