While lightly holding the end of
upper thread and start sewing.
Note:
Gently feed the fabric by hand.
Before stopping, the machine
will automatically sew a
reinforcement stitch after the
buttonhole is sewn.
Pull the buttonhole lever all the
way down and position it
behind the bracket on the
buttonhole foot.
Select the buttonhole stitch.
Adjust the stitch width and the
stitch length to the desired
width and density.
Position the fabric under the
presser foot with the front end
of the buttonhole mark aligned
with the center line on the
buttonhole foot.
Note:
When you select any buttonhole
pattern, LCD screen will be
demonstrated the figure " ", it
is to remind you to lower the
buttonhole lever.
Starting
point
To Next Page
Loading...
Need help?
General
