−68 −
8. VARIOUS DATA LIST
(1) Sewing data list
Sewing data are those that can be inputted to 99 patterns from pattern 1 to 99 and can be inputted to each pattern.
The sewing machine has been set in the state that the data which is necessary to set “With/without edit” cannot be
selected at the time of your purchase. Change over the function to “With edit” if necessary for the use. / Refer to
12. Method of setting sewing data with/without edit (Instruction Manual).
No.
S01
S02
S03
S04
S05
S06
S07
S08
S09
Item
Sewing shape
This item selects the shape from among the sewing shapes of 30
different kinds which the sewing machine has.
* Only 12 kinds of standard sewing shapes can be selected at the
time of your purchase. When increasing the kinds of shapes,
perform setting of K04 Sewing shape selection level$ of memory
switch data. / Refer to 8.-(2) Memory switch list.
Cloth cut length
This item sets the length of cloth that is cut by cloth
cutting knife. However, in case of bar-tack shape (Nos.
27, 28, 29, and 30 of S01), sewing length is set.
By making effective U19 Function of plural motions of cloth
cutting knife of memory switch data, make the plural motions of
knife by the knife size set in the item U18 Cloth cutting knife
size, and the sewing product is cut. / Refer to 8.-(2) Memory
switch list.
Knife groove width, right
This item sets the clearance between cloth cutting
knife and right parallel section.
Knife groove width , left
This item sets the clearance between cloth cutting
knife and left parallel section.
Overedging width, left
This item sets the overedging width of left parallel
section.
Ratio of right and left shapes
This item sets enlargement/reduction ratio of right side
shape making the knife position as the center.
Pitch at parallel section
This item sets sewing pitch of left and right parallel
sections.
2nd bar-tacking length
This item sets length of bar-tacking on the front side.
1st bar-tacking length
This item sets length of bar-tacking on the rear side.
Setting range
1 to 30
(30 shapes)
3.0 to 120.0
-2.00 to 2.00
-2.00 to 2.00
0.10 to 5.00
50 to 150
0.200 to 2.500
0.2 to 5.0
0.2 to 5.0
Edit unit
1
0.1mm
0.05mm
0.05mm
0.05mm
1%
0.025mm
0.1mm
0.1mm
Remarks
–
–
–
–
–
–
–
–
–
–
Bottom
of square
type
Bottom of
flow
Bottom of
straight bar-
tacking
Top of square
type
Refer to 2. Standard sewing
shape list.
* 1 : Displayed according to the shape
* 2 : Displayed when it is set to with edit. Refer to 12. Method of setting sewing data with/without edit (Instruction
Manual).
* 3 : Displayed when the function is selected.
To Next Page
Loading...
Need help?
General
