JUKI MO-1200QVP - Machine Preparation Steps; Attaching the Foot Control; Setting Up the Thread Stand

Preparing the machine
Attaching the foot control
Plug foot control into the machine socket (A) and then into the main
socket (B). The foot control regulates the sewing speed. The sewing
speed can be adjusted by increasing or decreasing the pressure on
the foot control.
“WARNING”
This appliance has a polarized plug (for USA and Canada only, one
blade wider than the other).
To reduce the risk of electric shock, this plug is intended to t in a
polarized main socket only one way.
If the plug does not t fully in the polarized main socket, reverse the
plug. If it still does not t, contact a qualied electrician to install the
proper polarized main socket. Do not modify the plug in any way. (for
USA, Canada only)
* Use only the foot control model YC-482 (USA, Canada), YC-483N
(220-240V).
Thread stand
Push the support rod rmly into the socket on the back of the ma-
chine. Raise the support rod (C) fully, turning slightly until the po-
sition catches engage. Position the thread guide (D) on the thread
stand so that the arrow is to the front.
Polarized plug
(for USA, Canada only)
Polarized main socket
7