2. Lower looper thread (Red)
Place the spool on the spool holder pin right under red marking on
the retractable support rod thread guide.
(1,2) Bring thread up from the rear of the retractable support rod
thread guide to the front of it.
(3,4) Pass the thread through the thread guide plate.
(5) Bring the thread on to the thread guide.
(6) Thread the thread tension dial.
(7,8,9,10,11) Thread the thread guides.
(12) Raise the needle fully and press the lever of the threading de-
vice down.
MO-654DEN only:
(13,14) Thread the guide and then the slit on the device. Holding
the thread loosely with the left hand, turn the handweel until
upper and lower loopers just cross. The threading device
will automatically return to the normal position.
(15) Thread the lower looper eye and place thread under the press-
er foot.
* If the lower looper thread is broken or slipped, cut the both needle
threads off at the needle. Then remove the thread.
Thread the lower looper and then the needles.
Threading (2)
MO-654DEN
18
To Next Page
Loading...
Need help?
General
