Quick Start Guide
EX2200-C
IN THIS GUIDE
Step 1: Begin | 1
Step 2: Up and Running | 4
Step 3: Keep Going | 6
Step 1: Begin
IN THIS SECTION
Mount the EX2200-C on Two Posts of a Rack | 2
Mount the EX2200-C on a Desk or Other Level Surface | 3
Connect Power to the EX2200-C | 3
To install and perform initial configuration of a Juniper Networks EX2200-C Ethernet Switch, the compact, fanless model,
you need:
For rack installation:
•
Two mounting brackets and eight mounting screws (separately orderable)
•
Screws to secure the chassis to the rack (not provided)
•
Phillips (+) screwdriver, number 2 (not provided)
For desk installation:
•
Four rubber feet (provided)
For connection to power and initial configuration:
To Next Page
Need help?
General
