Copyright © 2017, Juniper Networks, Inc. All rights reserved.
Juniper Networks, Junos, Steel-Belted Radius, NetScreen, and ScreenOS are registered trademarks of Juniper Networks, Inc. in the United States and other countries. The Juniper Networks Logo, the Junos logo, and JunosE are trademarks of Juniper
Networks, Inc. All other trademarks, service marks, registered trademarks, or registered service marks are the property of their respective owners. Juniper Networks assumes no responsibility for any inaccuracies in this document. Juniper Networks
reserves the right to change, modify, transfer, or otherwise revise this publication without notice. Part Number: 530-081626 Revision 01, November 2017.
Power O the Device
To power o the device, press the Power button on the front of the device and
hold it for 10 seconds. To remove power completely from the device, unplug the
AC power cord or DC power supply cable. After powering o a power supply,
wait at least 60 seconds before turning it back on.
NOTE: Graceful shutdown is not supported on the SRX550 High
Memory Services Gateway.
Reset the Configuration
Use the RESET CONFIG button to restore the device to the factory-default
configuration or to a rescue configuration. To press the RESET CONFIG button,
insert a small probe (such as a straightened paper clip) into the pinhole on the
front panel.
Pressing and quickly releasing the RESET CONFIG button loads and commits
the rescue configuration. The rescue configuration is a previously committed,
valid configuration set through J-Web or the CLI. The STATUS LED is solid amber
during this time.
Pressing and holding the RESET CONFIG button for 15 seconds or more,
until the STATUS LED is solid amber, deletes all configurations (backup
configurations and rescue configuration), and loads and commits the factory
configuration.
NOTE: After resetting the device, check the device status by viewing
the LEDs on the front panel. For information on the LED states, see the
“Power On the Device” section.
Next Steps:
For information on configuring features on your services gateway, refer to the
following:
• Junos OS Documentation/Feature Configuration
http://www.juniper.net/techpubs/en_US/release-independent/junos/
information-products/pathway-pages/srx-series/product/index.html
• Getting Started Knowledge Base Article
https://kb.juniper.net/InfoCenter/index?page=content&id=KB15694
Reference
Technical Support
http://www.juniper.net/support/requesting-support.html
SRX550 High Memory Services Gateway Hardware Guide
http://www.juniper.net/techpubs/en_US/release-independent/junos/
information-products/pathway-pages/hardware/SRX550/srx550-hm-index.
html
Supported Transceivers
https://pathfinder.juniper.net/hct/product/#prd=SRX550%20HM
To Previous Page
Loading...
Need help?
General
