Juniper SSG 320M User Manual

Juniper Networks SSG 320M and 350M Security Policy
7
Interfaces
The SSG 320M and 350M provide a number of interfaces:
• Four Ethernet autosensing 10/100/1000 interfaces (RJ-45). (Data Input, Data Output,
Control IN, Status OUT). These interfaces are network ports. Each port has two LEDs
that indicate port status:
Table 3: SSG 320M and 350M Ethernet Port LEDs
Name
Color
State
Description
Status (left)
Green
Steady
Link up
Off
Link down
TX/RX (right)
Green
Blinking
Indicates that traffic is
passing through
Off
Indicates that no traffic is
passing through.
• Console port – RJ-45 serial port connector (Data Input, Data Output, Status IN, Control
OUT). This port allows initial access to the Command Line Interface (CLI).
• Modem port – RJ-45 serial port connector. Disabled in FIPS mode.
• USB port. Disabled in FIPS mode.
• Power interface: AC or DC.
• The SSG has four status LEDs:
Table 4: Device Status LEDs
Name
Color
State
Description
Power
Green
Steady
Indicates that the unit is
receiving power
Off
Indicates that the unit is not
receiving power
Status
Green
Off
Indicates that the system is
starting or is powered off.
Blinking
Indicates that the device is
operating normally.
Alarm
Off
No alarm
Amber
Steady
Major alarm:
 Low memory (less than
10% remaining).
 High CPU utilization (more
than 90% in use).
 Session full.
 Maximum number of VPN
tunnels reached.
 HA status changed or
redundant group member
not found.
Red
Steady
Critical alarm:
 Failure of hardware
component or software
module.
 Firewall attacks detected.
HA (High
Availability)
Green
Steady
Unit is the primary (master)
device.

Juniper SSG 320M Specifications

General

Brand	Juniper
Model	SSG 320M
Category	Server
Language	English