3.4.1 Domestic hot water
The mounting template is removed
before mounting the mounting rail, fitting
board, and fittings.
3.4.3 Gas connection
B The mounting template must be placed in the
desired place on the wall and fixed to it.
B a safety kit is fitted which provides a connection
to a visible drain system in the event of an
overpressure in the circuit.
Heating system safety valve
Take off your coat
For reasons of electrical safety,
the jacket is secured with a screw
against unauthorized disassembly
(safety on the electrical side).
Hanging on the wall
evacuation.
B Attach the connection plate to the wall with
the supplied dowels and screws.
3.4.2 Heating system
Caution: Damage to the installation
may occur due to debris left over from
installation.
FIG. 4 Connection
B Remove the packaging, following the instructions on
11
B Drill a hole in the wall for the piping
If all valves are closed, the static pressure must not
exceed 10 bar.
The gas line must be located and dimensioned in such
a way as to ensure the supply of gas to all appliances
connected to it.
B Remove the right side locking screw.
B Drill holes for screws (Ø 8 mm).
It is intended to protect the heating system and
the appliance from possible overpressure. From the
factory, the safety valve comes into operation when
the circuit pressure reaches the value of about 3 bar.
The hot water pipes and fittings are placed
in such a way that, depending on the existing supply
pressure, there is a loss of water flow at all points of
its collection.
B The jacket must always be fastened
with this screw.
If the installation has a non-return valve or a
pressure limiter at the domestic water inlet:
Gas and water connection
the.
B Wash the mains to remove debris.
Installing
B A pressure limiter is fitted to the system.
B Secure the retaining rail with the two screws and
dowels, which are also supplied.
B Check the position of the rail and the connection plate
and tighten the screws.
Otherwise:
B Set aside the cloak, pulling it forward.
i
i
Heating tour
173 Cold water connection
43
47
114 Domestic hot water connection (1/2 ")
112 Gas connection
6 720 610 828 RO (02.01)
Heating return
3.4 Installation of pipes
3.5 Mounting the device
Machine Translated by Google
To Next Page
Loading...
Need help?
General