1-6 (No.MB177)
3.1.4 Removing the rear panel
(See Fig.7)
• Prior to performing the following procedure, remove the top
cover, side panels and stay bkt.
(1) From the top side on the main body, remove the protect
cover and the solders from the two solder points on the AC
inlet.
(2) From the bottom side on the main body, remove the four
screws J attaching the rear panel.
(3) From the back side on the main body, remove the forty-six
screws K, two screws L and three screws M attaching each
board to the rear panel.
3.1.5 Removing the audio signal 3 board & compu link board
(See Figs.7 and 8)
• Prior to performing the following procedure, remove the top
cover, side panels and stay bkt.
(1) From the top side of the main body, cut off the tie band
fixing the wire. (See fig.8)
(2) Disconnect the wire from the connector CN201
on the
audio signal 1 board. (See fig.8)
(3) From the back side of the main body, remove the two
screws L attaching the audio signal 3 board to the rear
panel. (See fig.7)
(4) From the top side of the main body, disconnect the wire
from the connector CN302
on the compu link board. (See
fig.8)
(5) Disconnect the wire from the connector CN207
on the
audio signal 1 board. (See fig.8)
(6) From the back side of the main body, remove the three
screws M attaching the compu link board to the rear panel.
(See fig.7)
Fig.7
Fig.8
3.1.6 Removing the Y/C separator board
(See Fig.9)
• Prior to performing the following procedure, remove the top
cover, side panels and stay bkt.
(1) From the top side of the main body, cut off the tie band
fixing the wire.
(2) Disconnect the connectors CN481
and CN482 on the Y/C
separator board, and take out the Y/C separator board
upward.
Fig.9
J
KK
AC inlet
Black
Red
Solder part
K
J J
K
K
Protect cover
L
K
Rear panel
K
K
K
M
Tie bands
Audio signal
3 board
CN201
Audio signal
1 board
Compu link
board
CN207
CN302
Y/C separator
board
CN481
CN482
Tie bands
To Next Page
Loading...
Need help?
General
