High Altitude Mode
For setting the high altitude mode to “On” or “Off”.
Set to
“On” when using the projector at a location of low atmospheric pressure (higher than 900 m (3,000 ft) above sea
level).
Lamp Reset
Resets the lamp time.
Æ “Resetting the Lamp Time” (P. 74)
Factory Reset
For restoring the settings of this unit to the factory default. However, the following settings will not be reset.
0
Gamma data saved in “Gamma” " “Correction Value” " “Import”.
0
Color profile data saved in “Color Profile” " “Custom1 to Custom6”.
Software Update
For performing a software update.
For the latest information on the software, refer to https://www3.jvckenwood.com/english/download/.
Information
Setting Description
Input Displays the currently selected video input terminal.
Source
(Displayed only during video signal input)
Displays the input source.
Resolution
(Displayed only during PC signal input)
Displays the image resolution.
H Frequency
Displays the horizontal frequency.
V Frequency
Displays the vertical frequency.
Color Depth
Displays the color space and color bit depth of the input video signal.
0
The color bit depth is not displayed when “YCbCr422” is input.
0
The color bit depth is displayed when color bit depth information is received
from the source device.
Color Space
Colorimetry Displays the Colorimetry of the input signal.
HDR Displays the EOTF information when HDR packet is received.
Max CLL/Max FALL Displays the mastering information of the content during HDR playback.
Max CLL: Maximum Content Light Level
Max FALL: Maximum Frame Average Light Level
0
The information may not be displayed depending on the player and content.
Lamp Time Displays the number of lamp hours used.
Soft Ver. Displays the firmware version.
71
Adjust/Set
To Next Page
Loading...
Need help?
General
