Video image looks unnatural
Colors are unnatural
Check Action Refer to
Is the color space of the input signal
correctly set?
The color may turn out unnatural when the input signal is
different from that in the projector setting.
Set the “Color Space” for “Input Signal” correctly.
P. 58
Is the image correctly adjusted? Adjust “Color” and “Tint” accordingly. P. 51
Is the AV device or PC properly
connected?
Connect the AV device or PC properly. P. 19
* The video image may appear slightly reddish immediately after starting up. This is not a malfunction.
Video image is fuzzy
Check Action Refer to
Is the focus correctly adjusted? Adjust the focus. P. 24
Is the unit placed too near or too far away
from the screen?
Set the unit at a correct distance from the screen. P. 87
Video image flickers
Check Action Refer to
Do you see horizontally-extended,
overlapping video images?
In this case, set “3D Format” to “Auto” P. 27
Are you viewing the video images under
a fluorescent light?
This is caused by interference between the 3D glasses with
the flickers of the fluorescent light.
View with the fluorescent light turned off.
—
Is “Aperture” set to “Auto 1” or “Auto 2”? Set “Aperture” to “Manual” P. 50
Projected image is dark
Check Action Refer to
Is the lamp near exhaustion? Check the lamp time in the “Information” menu.
Prepare a new lamp unit or replace as soon as possible
when the lamp is near exhaustion.
P. 71
Is the aperture closed? Increase the value of the “Aperture” setting. P. 50
Is “Lamp Power” set to “Low”? Set “Lamp Power” to “High” P. 50
Video image appears horizontally (vertically) extended
Check Action Refer to
Is “3D Format” set to “Side by Side”? Set “3D Format” to “Auto” P. 27
Is “Anamorphic” set to a setting other
than “Off”?
Set “Anamorphic” to “Off” P. 66
78
Troubleshooting
To Next Page
Loading...
Need help?
General
