Remote Code
For changing the remote control code.
0
You need to configure the remote control according to the settings of this unit.
On the remote control unit, press the [MENU] and [BACK] buttons at the same time for three seconds or longer to
switch the code.
0
The backlight of the remote control blinks 3 times: change the remote control code to “A”
0
The backlight of the remote control blinks 2 times: change the remote control code to “B”
Setting Description
A Change the remote control code from “B” to “A”.
B Change the remote control code from “A” to “B”.
Lamp Reset
For resetting the lamp time to “0”.
Æ “Resetting the Lamp Time” (P.
59)
Information
Setting Description
Input Displays video input terminal.
Source
(Displayed only during video signal input)
Displays the input source.
Resolution
(Displayed only during PC signal input)
Displays the image resolution.
H Frequency
(Displayed only during PC signal input)
Displays the horizontal frequency.
V Frequency
(Displayed only during PC signal input)
Displays the vertical frequency.
Deep Color Displays the color bit depth of the input video signal.
0
Not displayed when YCbCr (4:2:2) is input.
0
Displayed when Deep Color information is received from the source device.
Color Space Displays the color space of the input signal.
Lamp Time Displays the lamp time.
Soft Ver. Displays the firmware version.
PS Ver. Displays the version of image quality data.
56
Adjust/Set
To Next Page
Loading...
Need help?
General
