33
Some countries space AM stations 9 kHz apart,
and other countries use 10 kHz spacing.
On the main unit ONLY:
To select 10 kHz intervals, while holing down ¢
on the main unit in Standby mode, press
F STANDBY/ON on the main unit to turn on the
power. “10 kHz” appears on the display window.
To select 9 kHz intervals, while holing down 4
on the main unit in Standby mode, press
F STANDBY/ON on the main unit to turn on the
power. “9 kHz” appears on the display window.
NOTE
If the interval spacing is switched, the memory in
which the radio stations were stored will be erased.
You can tune in to FM or AM.
1 Press FM/AM.
Each time you press the button, the band will
be alternated between FM and AM.
Example:
2 Press TUNING or TUNING
to select the station (frequency).
Automatic tuning:
Hold down TUNING or TUNING until the
system starts searching, and then release the
button.
When a station of sufficient signal strength is
tuned in to, the system stops searching
automatically.
To stop searching manually, press
TUNING or TUNING .
Manual tuning:
Each time you press
TUNING
or
TUNING
, the frequency changes.
• When an FM stereo program is received,
the “ST” (Stereo) indicator lights.
• You can also select the station with
cursor
5 // .
NOTE
If the stereo FM program currently tuned in to is noisy,
you can improve the reception by pressing FM MODE
to switch to the monaural mode (“MONO” lights). If you
press FM MODE again, or tune in to another station,
the receiving mode returns automatically to the stereo
mode.
Setting the AM tuner
interval spacing
Cursor
(5 // )
PHONES
F
STANDBY/ON
button
¢
4
Selecting a station
Frequency
Listening to a radio broadcast
EXA1[UJ].book Page 33 Monday, January 19, 2004 1:54 PM
To Next Page
Loading...
Need help?
General
