17
1
Slide the remote control
mode selector to
RECEIVER.
2 Press BASS ADJUST.
Display on the receiver
3 While the selectable values are
flashing, press 2 or 3 (cursor)
to select the value of the bass
frequency.
• You can select “100 Hz”, “120 Hz” or
“140 Hz”.
• The initial setting is “100 Hz”. Select the
value for your desired bass sound.
4 While the selectable values are
flashing, press 5 or / (cursor)
to select the value of “Q” in the
display window.
• You can select “0.75”, “1” or “1.25”.
• The initial setting is “1”. Select the value for
your desired bass sound.
5 Press ENTER.
• The selected values are displayed for a
short time.
NOTE
• The adjustment of the bass sound does not change
the treble and bass sound level adjustments.
The CC CONVERTER function is designed to
provide natural sound by improving the playback
sound from low-bit-rate digital sources.
The function compensates for sound waves
dissipated during digital recording compression to
approximate the original analog sound. Sound is
reproduced with more bits (24 bit) and a wider
range of frequency (128 kHz, 176.4 kHz or
192 kHz).
1 Slide the remote control
mode selector to
RECEIVER.
2 Press CC CONVERTER.
• When the CC CONVERTER function is
activated, the CC CONVERTER lamp
(button) on the front panel of the receiver
lights up.
• Each time you press CC CONVERTER, the
display changes as follows.
- “CC CNVRTR 1”:
Plays back a digital source with non-
compressed sound signals (linear PCM).
- “CC CNVRTR 2”:
Plays back a digital source with
compressed sound signals (Dolby digital,
DTS, MP3 or WMA).
- “CC CNVRTR OFF”:
Cancels the CC CONVERTER function.
NOTE
• The initial setting is “CC CNVRTR 1”.
• The CC CONVERTER function does not work when
analog sound is selected as the sound source or
when 3D PHONIC is activated (
A
page 35). In such
cases, pressing CC CONVERTER only displays
“ANALOG SOURCE ”.
• The original range of frequency is automatically
detected and extended to a specific range.
When the original range is 32 kHz, 44.1 kHz or
48 kHz, the range is extended to 128 kHz,
176.4 kHz or 192 kHz respectively.
Adjusting the bass sound
Enhancing the playback
sound (CC CONVERTER)
Receiver
CC CONVERTER lamp (button)
For the locations of the remote
control buttons, refer to page 14.
Basic operations (continued)
EXA10[J_C_UJ]-02.fm Page 17 Tuesday, September 6, 2005 5:59 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
