64 EN
TW
3
1
6
789`
5
4
2
VCR BRAND
NAME
BUTTONS
(A) (B)
GE 1 1
9 2
9 `
9 4
MAGNAVOX 9 5
1 1
7 1
7 6
MITSUBISHI 6 7
6 8
NEC 3 7
3 8
PHILIPS 1 9
9 5
1 1
9 4
9 1
9 6
1 2
JVC 9 1
9 6
9 3
HITACHI 6 6
6 3
VCR BRAND
NAME
BUTTONS
(A) (B)
PHILIPS
3 3
7 2
SANYO 3 6
3 5
SHARP 1 5
1 `
SONY
6 5
6 `
3 9
3 1
TOSHIBA 6 9
6 1
ZENITH 1 6
RCA
9 2
9 4
6 6
6 3
9 `
PANASONIC
1 3
1 7
1 1
9 4
1 8
VCR CODE LIST
A
B
C
MBR SETSHIFT
Brand Setting
Before you can perform Random Assemble Editing
(Z pg. 65 – 67), or control the VCR using the
remote control, you must set the VCR brand.
SET REMOTE/VCR CODE
Before operation, make sure the lithium battery is
installed in the remote control (Z pg. 18).
1
SET REMOTE TO OPERATE VCR
Turn off the power to the VCR and point the
remote towards the VCR’s infrared sensor.
Then, referring to the VCR CODE LIST on the
left, press and hold MBR SET, and press button
(A) and then (B).
•The code is automatically set once you
release the MBR SET button, and the VCR’s
power comes on.
2
OPERATE VCR
Make sure the VCR’s power is on. Then, while
holding SHIFT, press the button on the remote
for the desired function. The functions the
remote can control are PLAY, STOP, PAUSE, FF,
REW and VCR REC STBY (you don’t need to
press SHIFT for this one).
You’re now ready to try Random Assemble
Editing.
IMPORTANT
Although the MBR is compatible with JVC VCRs
and those of many other makers, it may not work
with yours or may offer limited functions.
NOTES:
●
If the VCR’s power doesn’t come on in step 1, try
another code from the VCR CODE LIST.
●
Some brands of VCR don’t come on automati-
cally. In this case, turn the power on manually
and try step 2.
●
If the remote control is not able to control the
VCR, use the controls on the VCR.
●
When the remote control's battery runs out, the
VCR brand you have set will be erased.
In that case, replace the old battery with a new
one to reset the VCR brand.
VCR (Recording deck)
EDITING
(Cont.)
To Next Page
Loading...
Need help?
General
