TO MODE MENU
P
L
A
Y
/
P
C
O
F
F
C
A
M
E
R
A
5
S
D
S
C
D
S
C
P
L
A
Y
4
FLASH ADJ.
2
MANUAL
2
Flash Brightness Adjustment
When a snapshot (Z pg. 22, 30) is taken in the dark the
camcorder fires the flash (Z pg. 32) and adjusts the
brightness automatically. You can also adjust the flash
brightness manually. When you find that the snapshots
you took look too bright or too dark, adjust it manually.
1
SELECT OPERATION MODE
Set the Operation Switch to “ ”. Then, set the
Power Switch to “ ”, “5S” or “ ” while
pressing down the Lock Button. Pull out the view-
finder fully or open the LCD monitor fully.
2
ACCESS RECORDING MENU
Press MENU/SET. The Recording Menu appears.
3
SELECT FUNCTION
Rotate MENU/SET to move the highlight bar to
“FLASH ADJ.”, then press it. The parameter blinks.
4
ADJUST BRIGHTNESS OF FLASH
Rotating MENU/SET upward increases the number of
the brightness adjustment and rotating MENU/SET
downward decreases it.
•The adjustment range is from –3 to +3.
5
ACTIVATE BRIGHTNESS OF FLASH
Press MENU/SET twice. The flash brightness
adjustment is complete and the normal screen
reappears.
NOTES:
●
When the battery power is low or when “FLASH” is set
to “OFF” in the Mode Menu, the “FLASH ADJ.” setting
cannot be changed.
●
When you change the subject you are shooting or the
shooting location, set it back to ±0 as described in step 4
and take a snapshot to check the flash brightness. After
doing this adjust to your desired brightness.
MENU/SET Dial Power Switch
Recording Menu
Display
Lock Button
Power lamp
Operation Switch
To Next Page
Loading...
Need help?
General
