EN41
MAKE CONNECTIONS
1
JVC VCR EQUIPPED WITH REMOTE
PAUSE TERMINAL
Connect the editing cable to the Remote PAUSE
terminal.
JVC VCR NOT EQUIPPED WITH REMOTE
PAUSE TERMINAL BUT EQUIPPED WITH
R.A. EDIT CONNECTOR
Connect the editing cable to the R.A.EDIT
connector.
VCR OTHER THAN TYPE OR
Connect the editing cable to the RM-V700U’s
PAUSE-IN connector.
2
Insert a recorded tape into the camcorder and set the
Power Switch to “ ”.
3
Turn the VCR power on, insert a recordable tape and
engage the AUX mode (refer to the VCR’s
instructions).
NOTES:
●
If your VCR has an S-Video input connector or a SCART
connector compatible with Y/C signals, connect the
camcorder and the VCR using the provided S-Video
cable. This can improve the dubbed picture quality.
●
If you use the cable adapter, set the “Y/C”/“CVBS” video
out select switch as required.
Y/C : When connecting to a VCR which accepts Y/C
signals and uses an S-Video cable.
CVBS : When connecting to a VCR which does not
accept Y/C signals and uses an A/V cable.
S-Video
cable
To
J terminal
(JLIP)
Open
the cover.
To Video* output
and Audio output
connectors
To S-Video
output
connector
To Remote
PAUSE
RM-V700U
(optional)
VCR
TV
To PAUSE-IN
Editing cable
(ø3.5 mini-plug
cable) (optional)
If your VCR has the
SCART connector,
use the cable adapter.
“Y/C”/“CVBS”
video out
select switch
To AUDIO
(L/MONO),
VIDEO* and
-IN connectors
A/V
cable
CONTINUED ON NEXT PAGE.
* Connect when an S-Video cable is not used.
To Next Page
Loading...
Need help?
General
