70
EN
EDITING (VCR DECK) (cont.)
Dubbing
(from DVD to VCR)
You can dub selected scenes from the DVD disc to a cassette,
starting and stopping wherever you wish.
However, it is not possible to dub the copy-protected disc.
In such case, “ERROR” appears on the front display panel.
A
Load a cassette and place a disc.
For the VCR deck
Insert a cassette with the record safety tab intact.
For the DVD deck
A
Press
OPEN/CLOSE
(
x
) on the DVD deck to open the
disc tray.
B
Place the disc in the disc tray.
C
Press
OPEN/CLOSE
(
x
) on the DVD deck to close the
disc tray.
B
Prepare the VCR deck for dubbing.
A
Press
VCR
.
B
Press
SP/EP
to select recording speed.
C
Search for the point where you want to start dubbing
by pressing
PLAY
(
4
),
FF
(
5
) or
REW
(
3
) then
press
STOP
(
8
).
C
Prepare the DVD deck for dubbing.
A
Press
DVD
.
B
Search for the point where you want to start dubbing
by pressing
PLAY
(
4
),
FF
(
5
) or
REW
(
3
).
C
Press
PAUSE
(
9
) to pause playback a little before the
start point.
D
Start dubbing.
Press and hold
REC
(
7
), then press
PLAY
(
4
) on the
Remote.
●
“DUB” lights on the front display panel.
E
End dubbing.
Press
STOP
(
8
).
●
Be sure to press
STOP
(
8
) while the VCR indicator lights up on
the unit.
●
If you press
STOP
(
8
) or
EJECT
(
x
) with the DVD deck
selected, the dubbing stopped, but the opening screen is also
recorded.
NOTES:
●
You cannot start dubbing when the scan mode is set to the
progressive mode. Set it to the interlace mode. (
墌
pg. 82)
●
Set “ON SCREEN GUIDE” to “OFF” (
墌
pg. 81) if you do not
want to record the on-screen display for DVD discs during
dubbing.
●
There may be a discrepancy of several seconds between where
you intend editing to start, and where it actually starts.
●
The superimposed indication during the operation or dubbing
is not recorded.
●
Set “PICTURE CONTROL” to “EDIT”. (
墌
pg. 76)
●
Turn on the TV and select the VCR channel (or AV
mode).
●
Slide the
TV/VCR/DVD
switch to the right.
To Next Page
Loading...
Need help?
General
