Do you have a question about the JVC KD-G401 and is the answer not in the manual?
maximum power output (front) | 50 W per channel |
---|---|
maximum power output (rear) | 50 W per channel |
continuous power output (RMS) (front) | 19 W per channel into 4 Ω, 40 Hz to 20 000 Hz at no more than 0.8% total harmonic distortion |
continuous power output (RMS) (rear) | 19 W per channel into 4 Ω, 40 Hz to 20 000 Hz at no more than 0.8% total harmonic distortion |
load impedance | 4 Ω (4 Ω to 8 Ω allowance) |
tone control range (bass) | ±10 dB at 100 Hz |
tone control range (treble) | ±10 dB at 10 kHz |
frequency response | 40 Hz to 20 000 Hz |
signal-to-noise ratio | 70 dB |
line-out level/impedance | 2.0 V/20 kΩ load (full scale) |
output impedance | 1 kΩ |
operating voltage | DC 14.4 V (11 V to 16 V allowance) |
---|---|
allowable operating temperature | 0°C to +40°C |
dimensions (W × H × D) | 182 mm × 52 mm × 150 mm |
panel size | 188 mm × 58 mm × 11 mm |
mass | 1.3 kg (excluding accessories) |
frequency response | 5 Hz to 20 000 Hz |
dynamic range | 96 dB |
signal-to-noise ratio | 98 dB |
max. bit rate | 320 Kbps |
frequency range (FM) | 87.5 MHz to 108.0 MHz |
---|---|
frequency range (AM MW) | 522 kHz to 1 620 kHz |
frequency range (AM LW) | 144 kHz to 279 kHz |
usable sensitivity | 11.3 dBf (1.0 µV/75 Ω) |
50 dB quieting sensitivity | 16.3 dBf (1.8 µV/75 Ω) |
alternate channel selectivity (400 kHz) | 65 dB |
frequency response | 40 Hz to 15 000 Hz |
stereo separation | 30 dB |
capture ratio | 1.5 dB |
sensitivity (MW) | 20 µV |
selectivity (MW) | 35 dB |
sensitivity (LW) | 50 µV |