ENGLISH
33REFERENCES
Detaching a USB device
• After removing a USB device, “NO USB“ appears and
you cannot operate some of the buttons. Reattach a
USB device or press SRC to select another playback
source.
Bluetooth operations
General
• While driving, do not perform complicated operation
such as dialing the numbers, using phone book, etc.
When you perform these operations, stop your car in
a safe place.
• Some Bluetooth devices may not be connected to
this unit depending on the Bluetooth version of the
device.
• This unit may not work for some Bluetooth devices.
• Connecting condition may vary depending on the
circumstances around you.
• When the unit is turned off, the device is
disconnected.
Warning messages for Bluetooth operations
ERR CNCT
(Error
Connection)
The device is registered but the
connection has failed. Use “CONNECT”
to connect the device again. (See page
15.)
ERROR Try the operation again. If “ERROR”
appears again, check if the device
supports the function you have tried.
UNFOUND No available Bluetooth device is
detected by “SEARCH.”
LOADING The unit is updating the phone book
and/or text messages.
WAIT The unit is preparing to use the
Bluetooth function. If the message does
not disappear, turn off and turn on the
unit, then connect the device again (or
reset the unit).
RESET 8 Check the connection between the
adapter and this unit.
DAB
• Only the primary DAB service can be preset even
when you store a secondary service.
• A previously preset DAB service is erased when a new
DAB service is stored in the same preset number.
iPod or D. player
• When you turn on this unit, the iPod or D. player is
charged through this unit.
• While the iPod or D. player is connected, all
operations from the iPod or D. player are disabled.
Perform all operations from this unit.
• The text information may not be displayed correctly.
• If the text information includes more than 8
characters, it scrolls on the display. This unit can
display up to 40 characters.
Notice:
When operating an iPod or a D. player, some
operations may not be performed correctly or as
intended. In this case, visit the following JVC web
site:
For iPod users: <http://www.jvc.co.jp/english/
car/support/ks-pd100/index.html>
For D. player users: <http://www.jvc.co.jp/
english/car/support/ks-pd500/index.html>
General settings—PSM
• “AUTO” setting for “DIMMER” may not work correctly
on some vehicles, particularly on those having a
control dial for dimming.
In this case, change the “DIMMER” setting to any
other than “AUTO.”
• If you change the “AMP GAIN” setting from
“HIGH PWR” to “LOW PWR” while the volume level
is set higher than “VOL 30,” the unit automatically
changes the volume level to “VOL 30.”
EN30-39_KD-G731_003A_f.indd 33EN30-39_KD-G731_003A_f.indd 33 12/12/06 9:36:42 AM12/12/06 9:36:42 AM
To Next Page
Loading...
Need help?
General
