28
ENGLISH
SOUND ADJUSTMENTS
Adjusting the sound
You can set the speaker output balance, subwoofer
output level, and input level of each source.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step
1
again.
1
Select the item you want to adjust.
The next-step-operation
buttons start flashing.
Each time you press the
button, the adjustable items
change as follows:
Indication To do: Range
Fad Adjust the front R06 (Rear only)
and rear speaker |
balance. F06 (Front only)
Bal Adjust the left L06 (Left only)
and right speaker |
balance. R06 (Right only)
Sub Out Adjust the 00 (min.)
subwoofer output |
level and cutoff 08 (max.)
frequency level. Low/Mid/High
Vol Adj Adjust and store –12 (min.)
the input level |
of each source. +12 (max.)
2
Adjust the level.
• To adjust fader and balance—Fad, Bal:
You can make these two adjustments at
the same time.
• If you are using a two-speaker system,
set the fader level to “00.”
• Press 5 (up) or ∞ (down)
to adjust the fader.
• Press ¢ or 4
to adjust the balance.
• To adjust subwoofer output—Sub Out:
This takes effect only when a subwoofer is
connected.
You can also set an appropriate cutoff
frequency level according to the subwoofer
connected.
• Press ¢ or 4 to select “Low,”
“Mid,” or “High.”
Low: Frequencies higher than 50 Hz are
cut off to the subwoofer.
Mid: Frequencies higher than 80 Hz are
cut off to the subwoofer.
High: Frequencies higher than 115 Hz are
cut off to the subwoofer.
To decrease the level
To increase the level
Fad (Fader)
Bal (Balance)
Vol Adj
(Volume Adjustment)
Canceled
Sub Out
(Subwoofer Output)
EN28-31_KD-LH3150_3100[J]f.p65 2/21/03, 10:05 AM28
To Next Page
Loading...
Need help?
General
