JVC KD-S743R User Manual

15
ENGLISH
Changing the display mode while
listening to an FM station
You can change the initial indication on the
display to station name (PS NAME), station
frequency (FREQ), or clock time (CLOCK) while
listening to an FM RDS station.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items
appears on the display. (See page 23.)
2 Press ¢ or 4 to select
“DISPMODE” (display mode).
3 Press + or – to set to the desired indication
(“PS NAME,” “FREQ,” or “CLOCK”).
4 Press SEL (select) to finish the setting.
Note:
By pressing DISP (display), you can change the
display while listening to an FM RDS station.
Each time you press the button, the following
information appears on the display:
• Then, the display goes back to the original
indication in several seconds.
Setting the TA volume level
You can preset the volume level for TA Standby
Reception. When a traffic programme is received,
the volume level automatically changes to the
preset level.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items
appears on the display. (See page 23.)
2 Press ¢ or 4 to select “TA VOL”
(volume).
3 Press + or – to set to the desired volume.
You can set it from “VOL 00” to “VOL 50.”
4 Press SEL (select) to finish the setting.
Automatic clock adjustment
When shipped from the factory, the clock built in
this unit is set to be readjusted automatically using
the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock
adjustment, follow the procedure below.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items
appears on the display. (See page 23.)
2 Press ¢ or 4 to select “AUTO
ADJ” (adjustment).
3 Press – to select “OFF.”
Now automatic clock adjustment is canceled.
4 Press SEL (select) to finish the setting.
To reactivate clock adjustment, repeat the same
procedure and select “ON” in step 3 by pressing +.
Note:
You must stay tuned to the same station for more than
2 minutes after setting “AUTO ADJ” to “ON.”
Otherwise, the clock time will not be adjusted. (This is
because the unit takes up to 2 minutes to capture the
CT data in the RDS signal.)
Station name
(PS NAME)
Station frequency
(FREQ)
Programme type
(PTY)
Clock
(CLOCK)
EN10-16_KD-S743R[E_EX]f.p65 11/18/02, 6:40 PM15

JVC KD-S743R Specifications

General

Brand	JVC
Model	KD-S743R
Category	Car Receiver
Language	English