9
ENGLISH
Manual preset
You can preset up to 6 stations in each band
(FM1, FM2, FM3, and AM) manually.
Ex.: Storing FM station of 88.3 MHz into the
preset number 1 of the FM1 band.
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
2
Tune in to a station (in this example,
of 88.3 MHz).
3
Press and hold the number button
(in this example, 1) for more than 2
seconds.
To tune in to stations of lower
frequencies
To tune in to stations of higher
frequencies
FM1 FM2 FM3
AM
FM
AM
“P1” flashes for a few seconds.
7
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example,
during battery replacement). If this occurs, preset
the stations again.
Tuning in to a preset station
You can easily tune in to a preset station.
Remember that you must store stations first. If
you have not stored them yet, see “Storing
stations in memory” on pages 8 and 9.
1
Select the band (FM1 – 3, AM).
2
Select the number (1 – 6) for the
preset station you want.
FM1 FM2 FM3
AM
FM
AM
910 127
RND
11
RPT
8
MO
EN07-09_KD-S743R[E_EX]f.p65 11/18/02, 6:41 PM9
To Next Page
Loading...
Need help?
General
