4
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
GETTING STARTED
Cancel the demonstration
When you turn on the power for the first time (or [
FACTORY RST
] is set to
[
YES
]), the display shows: “CANCEL DEMO” “PRESS” “VOLUME KNOB”
1 Press the volume knob.
[
YES
] is selected for the initial setup.
2 Press the volume knob again.
“DEMO OFF” appears.
Set the clock
1
Press and hold .
2 Turn the volume knob to select [
CLOCK
], then press the knob.
3 Turn the volume knob to select [
CLOCK SET
], then press the knob.
4 Turn the volume knob to make the settings, then press the knob.
Day
Hour Minute
5 Turn the volume knob to select [
24H/ 12H
], then press the knob.
6 Turn the volume knob to select [
12 HOUR
] or [
24 HOUR
], then press the
knob.
7 Press to exit.
To return to the previous setting item, press .
1
2
Set the basic settings
1
Press and hold .
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 Repeat step 2 until the desired item is selected or activated.
4 Press to exit.
To return to the previous setting item, press .
Default:
XX
SETTINGS
BEEP
(Not applicable when 3-way crossover is selected.)
ON
:Activates the keypress tone.;
OFF
:Deactivates.
SRC SELECT
AM
*
1
ON
:Enables AM in source selection.;
OFF
:Disables.
AUX
*
1
ON
:Enables AUX in source selection.;
OFF
:Disables.
F/W UPDATE
SYSTEM
/
DAB 1
*
2
/
DAB 2
*
2
F/W UP xxxx/
F/W UP xxxxx/
F/W UP Vxxx
YES
:Starts upgrading the firmware.;
NO
:Cancels (upgrading is not
activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
FACTORY RST YES
:Resets the settings to default (except the stored station).;
NO
:Cancels.
*
1
Not displayed when the corresponding source is selected.
*
2
For
KW-DB92BT
.
3
JS_JVC_KW_R920BT_DB92BT_E_EN_3.indd 4JS_JVC_KW_R920BT_DB92BT_E_EN_3.indd 4 13/11/2015 4:25:27 PM13/11/2015 4:25:27 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
