8
Please read P. 9 - 17 of this manual to set up your TV.
Use two “AAA/R03” dry cell batteries. Insert the batteries from the - end,
making sure the + and - polarities are correct.
Check accessories
Install your TV
䡵 Power requirements
z Connect the power cord only to a 220 - 240 V, 50 Hz AC outlet.
䡵 When attaching the TV to the wall, use the optional JVC wall mounting
unit
z Consult a qualified technician.
z See the included manual on mounting procedures.
z JVC assumes no responsibility for damage due to improper mounting.
z Mounting holes for wall mounting unit:
M5 x 4, 400 mm x 200 mm
Depth of screw hole is 13 mm from the surface of the TV.
䡵 Installation requirements
z To avoid overheating, ensure the unit has ample room.
Remote control
R90: RM-C1932
DR9: RM-C1931
“AAA/R03” Batteries
(For confirming the TV
works)
Cleaning cloth
(For details on using the
cleaning cloth, see P. 7.)
WARNING:
Batteries shall not be exposed to
excessive heat such as direct
sunshine, fire or the like.
200 mm
150 mm 50 mm
150 mm 50 mm
Insert the batteries
Watch pay-TV digital channels (DR9 only)
Subscribe to a broadcasting company beforehand.
A Smart Card (B) will be sent by the broadcasting
company after subscribing to it. It may be
necessary for you to purchase a Conditional
Access Module (A) in addition to the Smart Card.
Consult your broadcasting company or retailer.
A Unplug the power cord
B Insert “B” into “A”.
C Insert “A”.
D Plug the power cord, and turn the power on.
E Perform necessary settings using “Common
Interface”.
g
z Pay-TV analogue channels cannot be
watched.
WATCHING DIGITAL CHANNELS
“Common Interface” (P. 13)
A
B
Getting started
LT-42DR9BU.book Page 8 Tuesday, February 19, 2008 11:46 AM
To Next Page
Loading...
Need help?
General
