38
IMPORTANT PREPARE USE SETTING TROUBLE?
Decoder(EXT-2)
Select “On” when connecting the Decoder to EXT-2 through the
VCR (On / Off)
Component Auto
Select
Changes the TV input to “EXT-4” when a component signal is input
to EXT-4 (On / Off)
z Not available when viewing PC
EXT Setting
g “Setting external terminals” (P. 23)
HDMI Setting
Size :
If picture size is not correct in 480p(525p), change this setting to 1
or 2. Normally set to “Auto”.
Audio :
If there is no sound, change this setting to “Digital” or “Analogue”.
Normally set to “Auto”.
HDMI CEC :
If you use a HDMI CEC compatible device, set this setting to “On”.
z For more details g “What is “HDMI CEC”?” (P. 43)
Attenuator
Select “On” when digital channels are not received because of too
strong radio waves (On / Off)
z “Attenuator” attenuates the radio waves of analogue broadcast as well as
those of digital broadcast. If some noise or snow appears when watching
an analogue channel, please set “Attenuator” to “Off” temporarily.
PC Position
Adjust the position of the PC image
Auto
Demonstration
Starts the “100Hz Clear Motion Drive” demonstration (On / Off)
(P. 44)
AutoSize
HDMI
-3
HDMI CEC
HDMI
-1
Auto
Auto
Size
Audio Auto
On
Size
HDMI Setting
HDMI
-2
Note
adjust
(blue)
Reset
PC Position
LT-42DV8BJ.book Page 38 Friday, July 6, 2007 11:23 AM
To Next Page
Loading...
Need help?
General
