11
Preparation
NOTE
• “480”, “576”, “720” and “1080” refer to the num-
ber of the scanning lines. Generally, the larger
the number, the better picture that can be
obtained.
• “I” refers to the interlaced format. “P” refers to
the progressive format. A better picture can be
obtained in the progressive format than in the
interlaced format.
• When an HDMI video signal is output, the
“HDMI” indicator lights up in the display window.
• When an HD video signal is output, the “HD”
indicator lights up.
• When “PAL. 576P”, “PAL. 720P”, “PAL.1080P”,
“NT. 480P”, “NT. 720P” or “NT.1080P” is
selected, the “PROGRESSIVE” indicator lights
up in the display window.
5 Press [ENTER].
NOTE
• It is recommended that you slide the remote
control mode selector to [AUDIO] after selecting
the video signal type. Most of the other functions
can be used when the remote control mode
selector is at [AUDIO].
• To check the compatibility of your TV, contact
your local JVC customer service center.
• Even if the main unit is turned off, the video sig-
nal type setting is stored.
Preparation (continued)
For the locations of the remote
control buttons, refer to page 10.
Do not connect the power cable until
all other connections have been made.
NX-F3_NX-F7[A]EN.book Page 11 Tuesday, April 22, 2008 1:55 PM
To Next Page
Loading...
Need help?
General
