Introduction
4
The numbers refer to the pages in which the parts
are explained.
NOTE
*
[K2] is printed on the remote control for NX-F7
only.
Insert the batteries into the remote control by
matching the polarity (+ and −) correctly.
• If the range or effectiveness of the remote con-
trol decreases, replace both batteries.
Point the remote control directly at the
front of the main unit.
• Do not block the remote control sensor on the
main unit.
Inserting the batteries into
the remote control
Operating the system from
the remote control
R03 (UM-4)/AAA
(24F) type dry-cell
batteries (supplied)
Using the remote control
NX-F3_NX-F7[A]EN-02.fm Page 4 Wednesday, May 14, 2008 5:08 PM
To Next Page
Loading...
Need help?
General
